Informationen zu dieser Version Version 1.0.7. You need to change the load behaviour in the Add-in Manager, this is accessed through the 'Tools' tab & then the '+ Add-Ins' Icon. If you tick 'Load Automatically' (bottom right hand corner) it should activate the add on every time you start inventor. Downloaded 3D DXF from manufacturers website Opened DXF in Inventor: Locks up Opened DXF in Rhino 5: OK Saved as STL and 3ds-file with Rhino 5 Imported STL in Inventor: OK, I see the mesh, but it's no solid. Applying Mesh Enabler on imported STL/Saved as IPT: Locks up Imported 3dm in Inventor: Result is an 'empty' modelfile Downloaded 3D DXF again from manufacturers website and gone trough the whole process again: No change I have no 'mesh knowledge' Please, what now? I need the solid. Thx and best regards.Äownload the Mesh Enabler at the Autodesk Exchange Apps to convert the Mesh to an Inventor solid or composite surface: The Add-In will install on Inventor 2013,20. Note: Available to subscription customers only. I'm using Inventor 2016 Pro on 8.1 64bit with the newest Mesh Enabler and have the same problem. It fills up all 8gb of ram but only uses about 30% of my i5 2.5 ghz. Thereby it kills every other program, of course, but even after an hour and a half of doing its thing, no response, no result. I notice another Inventor window that's just the inventor Icon open in the task bar called AdInventorButton or somesuch.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |